Minimal-X Adapter Board 30pin

To the -> Shop!

Short description: Makes I2C, SPI, UART and 1-Wire readily accessible as header pins/plug/connector. Used for stand alone implementations where maximal one sensor per port will be used, or in combination with the extension board for many more possibilities.

 

Hardware: Intended for DOIT ESP32 DevKitV1 or corresponding development boards. See the Minimal-X Board version if you have a Heltec WiFi Lora 32 or the corresponding TTGO.

 

Problem: You have a DOIT ESP32 DevKitV1 development board and are tired of wiring the I2C, SPI, UART and 1-Wire ports again and again with lose wires making up a birds nest.

Solution: All typical ports are lines up as pin header plugs/connectors for easy extraction  – each including ground, 3.3V and 5V.

 

Goodies:

1.) You also have the space for components for one voltage divider (through hole resistors).

2.) Get further sensor connectors by plugging it into the extension board “Minimal-X Extension Board”

 

Features (Version L30pin_v3)

  • 1 x I2C connector
  • 1 x 1-Wire connector
  • 1 x SPI connector
  • 1 x UART connector
  • 1 x analogue port
  • Turn power off on all the headers/connectors

To the -> Shop!